Initial Activation and Setup - Verizon Wireless Fivespot AC30
Is this helpful?  
Cancel  

Initial Activation and Setup - Verizon Wireless Fivespot AC30

  1. Connect the Fivespot AC30 to the computer via the supplied USB cable.
  2. Turn power on.
    Note Press and hold the power button for 3-5 seconds.
    Note Driver installation may take several moments.
  3. Install VZAccess® Manager.
  4. Perform activation.
    Note Refer to Performing Over-The-Air Activation for additional assistance.
  5. Connect to the Internet.
    • Tethered as a USB modem
      Note To enable USB Modem mode: power the device off, connect via supplied USB cable then power the device on.
    • Wireless via Wi-Fi
      Note To enable Wi-Fi mode: power the device off, disconnect USB cable then power the device on.
      Note The default SSID/Password are Verizon AC30 XXXX/MEID (in decimal format, located on the bar code label under the battery).
Last Modified: February 22, 2013
Is this helpful?  
Cancel