Connect and Power On the Device - 4G LTE Network Extender for Enterprise

The 4G LTE Network Extender for Enterprise is an advanced business solution that's not available for consumer use.

Warning Do not connect the AC Adapter (Power Supply) into a Power Outlet until instructed. Doing so may cause an electrical short or power surge to the Network Extender.

Note The first time the Network Extender is setup it will be usable within 15 minutes and may take up to two hours before all features are fully functional. If the GPS LED is still red after one hour, relocate the GPS antenna to receive a stronger signal. Refer to Install the GPS Extension Cable for assistance.

  1. From the connection side of the Network Extender, attach the supplied Ethernet cable from the network extender B/H Port to an available LAN/Ethernet port on the router/modem.
    Connecting the ethernet cable from the router / modem to the device
  2. Connect the provided power supply to the Network Extender and ensure that the power supply is connected to the power cord then connect it to an available power outlet.
    Note The use of a surge protector is recommended.
    Connecting the power supply to a power outlet and PWR port
  3. Verify that the LED Status Indicators are illuminated correctly.
    Note Allow up to two hours for the Network Extender to complete initial startup.
    Note Refer to Meaning of LED Status Indicators for assistance.
isTealiumFlag=true