Arlo Go - Remove SD (Memory) Card

Caution Don't attempt to remove the SD (Memory) Card while the device is powered on. Doing so may harm the SIM card and/or the device.

  1. Ensure the camera is disconnected from the power adapter.
  2. Open the battery door.
    Note Press and hold the latch (located on the top edge) then rotate the door down.
  3. If present, remove the battery as shown.
    Note Utilizing the notches on both sides, pull to remove.
    Remove battery
  4. Remove the SD (Memory) Card from the slot as shown.
    Note If necessary, press in on the card to unlock it.
    Note If applicable, refer to Insert the SD (Memory) Card.
    Remove SD (Memory) Card
  5. If applicable, insert the battery as shown.
    Note Ensure that the connectors on the battery align with the connectors on the device.
    Insert battery
  6. Close the battery door.
    Note Rotate the door up and ensure it locks into place.
    Close battery door
isTealiumFlag=true