Initial Activation and Setup - V-Type Device (4G) - Cold Chain

  1. To activate the device: Using a pen, press the Mode button to turn the device on.
    Note A press for 0.1 second is sufficient. A yellow LED starts and stops flashing after device gets GPS location and sends an update to the server.
    Mode button
  2. The device activates automatically when powered on.
  3. To power cycle the device:
    1. To turn off the device: Use a pen to press and hold the Mode button until yellow LED starts glowing.
      Note Normally it takes 5-6 seconds until yellow LED starts glowing. Yellow LED glows for 3 seconds.
    2. To turn on the device: Using a pen, press the Mode button to turn the device on.
      Note A press for 0.1 second is sufficient. A yellow LED starts and stops flashing after device gets GPS location and sends an update to the server.
  4. To charge the device: Plug in any standard Micro-USB charger to charge the device.
    Note Important information about charging:
    • Device limits charging current to 1 A for safety.
    • Charging time for device with 50% remaining charge takes about 4 –5 hours.
    • Full charge time for totally depleted battery takes about 10 –11 hours with 1A charger.
      • To perform a power check, click the small round button for less than 1 second and the LED light flashes.
      • The alternative method to perform a power check, flip the device upside down 4 times then flip back to the original position and the lights show a tricolor flash for about 5 seconds.
    • Green LED flashes when battery is charging.
    • Green LED is constantly glowing when battery is fully charged.
    • Yellow LED shows device status is higher priority rather than green and will override. 
      Device charging

 

Device Features

  • Battery
  • Temperature sensor
  • 4G LTE Module
  • GPS Location tracking

V Type device

 

isTealiumFlag=true