Verizon Jetpack® MiFi® 8800L - Advanced Settings

To change the advanced settings (e.g., VPN Passthrough enable, Network Name broadcast enable, etc.) on your Jetpack, view this info.

Caution Changing advanced settings may be harmful to the stability, performance, and security of the Jetpack. Contact your local IT administrator prior to altering any of these settings.

  1. Access the Admin Web Interface.
  2. Click Jetpack Settings.
  3. Click the Advanced tab, review the warning then click Continue.
  4. Click any of the following (located below the Advanced tab):

 

Networks

Note For info regarding APN settings, refer to Edit Access Point Name (APN).

  1. From the Mobile Network section, click the switch to turn mobile data on or off.
  2. From the Network Settings section view the Network mode (LTE/UMTS).
    Note If needed, click Select network manually > Scan for Networks to search for other available networks.
  3. Click Save Changes.

 

Back to Advanced options
Top

 

Manual DNS

Caution Domain Name Server (DNS) settings are automatically assigned by the device. If turning on manual DNS is necessary, contact your local IT administrator for assistance.

  1. Select Turn on Manual DNS to turn on or off.
    Note On when a check mark is present.
  2. From the DNS 1 IP address and DNS 2 IP address fields, enter the appropriate info.
  3. Click Save Changes.

 

Back to Advanced options
Top

 

SIM

Note Refer to Turn SIM PIN On / Off.

 

Back to Advanced options
Top

 

Firewall

  1. Tap the switch for any of the following to turn on or off:
    • VPN Passthrough
    • IPv6 Transparent Mode
  2. From the DMZ (IPv4) section, select DMZ to turn on or off.
    Note On when a check mark is present.
    Note If on, enter the appropriate IP address into the Destination IP address field.
  3. Click Save Changes.

 

Back to Advanced options
Top

 

MAC Filter

Note Refer to MAC Filtering.

 

Back to Advanced options
Top

 

LAN

  1. From the IPv4 section, enter the desired info into the following fields:
    • IP Address
    • Subnet Mask
    • MAC Address
    • Turn on DHCP server
      Note On when a check mark is present.
    • DHCP lease time
    • Start DHCP address range at
  2. From the IPv6 section, select Turn on IPv6 to turn on or off.
    Note On when a check mark is present.
  3. Click Save Changes.

 

Back to Advanced options
Top

 

Port Filtering

Note Refer to Port Filtering.

 

Back to Advanced options
Top

 

Port Forwarding

Note Refer to Port Forwarding.

 

Back to Advanced options
Top

 

VPN

Note When an OpenVPN tunnel is established, all connected device traffic is sent through the tunnel and settings such as Port Filtering and Port Forwarding don't apply.

  1. Click the Auto-connect VPN switch to turn on or off.
  2. If VPN is configured, view the Connection status and Connection time from the VPN Connection section.
    Note You can also click View log to view past connection info.
  3. From the VPN settings section, enter the Username and Password in to the fields.
  4. If needed, drag and drop files from your VPN provider into the Setup files box.
  5. To delete saved VPN info, click Clear all VPN settings.
  6. Click Save Changes.

 

Back to Advanced options
Top

isTealiumFlag=true