moto z4 - Set Up Screen Lock

Note Notes:

  • If using Microsoft® Exchange / Corporate sync, some screen lock options may be unavailable.
  • These steps can also be utilized to change your current screen lock setting.

 

  1. From a Home screen, swipe up to access all apps.
  2. Navigate: Settings Settings icon > Security & location Security and Location icon.
  3. From the Device security section, tap Screen lock.
    Note If presented, enter the current PIN, password, or pattern.
  4. Select one of the following:

 

None

If prompted, review the notification regarding device protection then tap YES, REMOVE to confirm.

 

Top

 

Swipe

Note A lock screen requiring a left or right swipe is created to access the device.

If prompted, review the notification regarding device protection then tap YES, REMOVE to confirm.

 

Top

 

Pattern

Note An unlock pattern is created to access the device.

  1. Draw an unlock pattern (connecting at least 4 dots) then tap NEXT.
  2. Draw the same pattern again then tap CONFIRM.
  3. If presented, select an option then tap DONE (lower-right):
    • Show all notification content
    • Hide sensitive notification content
    • Don't show notifications at all

 

Top

 

PIN

Note A PIN is created to access the device.

  1. If presented with the PIN policy screen, tap OK.
  2. Enter a numeric PIN (4 to 16 digits) then tap NEXT.
  3. Re-enter the numeric PIN then tap CONFIRM.
  4. If presented, select an option then tap DONE (lower-right):
    • Show all notification content
    • Hide sensitive notification content
    • Don't show notifications at all

 

Top

 

Password

Note A password is created to access the device.

  1. If presented with the Password policy screen, tap OK.
  2. Enter a password (4 to 16 characters) then tap NEXT.
  3. Re-enter the password then tap CONFIRM.
  4. If presented, select an option then tap DONE (lower-right):
    • Show all notification content
    • Hide sensitive notification content
    • Don't show notifications at all

 

Top

isTealiumFlag=true