Add a Virtual Private Network - BlackBerry® Z30

Note Contact the VPN administrator for assistance with server information and credentials.

  1. From the home screen, select Settings.
    Note If not available, swipe down from the top of the display (where the time is located).
  2. Select Network and Connections.
  3. Select VPN.
  4. Select Add VPN profile.
    Note If not available, select Add (at bottom of the screen).
  5. Enter or configure the following settings:
    Note Depending upon the Gateway Type selected, the available settings vary.
    • Profile Name
    • Server Address
    • Gateway Type
      • Check Point Software Technologies VPN-1
      • Cisco VPN 3000 Concentrator
      • Cisco Secure PIX Firewall VPN
      • Cisco IOS with Easy VPN Server
      • Cisco ASA
      • Juniper IPsec VPN (SRX Series)
      • Juniper IPsec VPN (NetScreen Series)
      • Juniper SSL VPN (MAG/SA Series)
      • Microsoft IKEv2 VPN Server
      • Generic IKEv2 VPN Server
    • Authentication Type
      • PSK
      • PKI
      • XAUTH-PSK
      • XAUTH-PKI
      • IPv4
      • Fully Qualified Domain Name
      • Email Address
      • EAP-TLS
      • EAP-MSCHAPv2
    • Authentication ID Type
    • Group Username
    • Group Password
    • Hardware token
      Note Enabled when a check mark is present.
    • Username
    • Password
  6. If applicable, select Advanced (at bottom of the screen).
    Note If the keyboard is present, select and hold the space bar Space bar icon to close the keyboard and view the hidden options.
    Note If advanced options are not applicable, skip to step 8.
    1. Select the On/Off switch for any of the following to enable On switch icon or disable Off switch icon:
      • Automatically determine IP
      • Automatically determine DNS
      • Automatically determine algorithm
    2. Enter desired amount of seconds in the following fields:
      1. IKE Lifetime (seconds)
      2. IPSec Lifetime (seconds)
      3. NAT Keep Alive (seconds)
      4. DPD Frequency (seconds)
    3. Select the On/Off switch for any of the following to enable On switch icon or disable Off switch icon:
      • Disable banner
      • Use HTTP proxy
  7. Select Save (at bottom of the screen).
    Note If the keyboard is present, select and hold the space bar Space bar icon to close the keyboard and view the hidden options.
isTealiumFlag=true